Should the fiber optic receiver be connected to the router or

The fiber optic receiver (ONT) should be connected to your router via an Ethernet cable, not directly.

How the Connection Works

Fiber optic cables carry data as light signals, which standard routers cannot interpret directly. The Optical Network Terminal (ONT), provided by your ISP, converts these light signals into electrical signals that your router can use.

The ON

T acts as the bridge between the fiber network and your home network.

Step-by-

Step Setup

Fiber Cable to ONT: Connect the fiber optic cable from the wall outlet to the ONT's optical input port. Handle the fiber connector carefully to avoid dirt or damage.

Power the ON

T: Plug in the ONT and wait for it to boot up and establish a connection with your ISP's network.

ON

T to Router: Use a high-quality Ethernet cable (Cat6 or better) to connect the ONT's Ethernet/LAN port to the WAN port on your router. Power the Router: Once the ONT is stable, power on your router and check the indicator lights to confirm a successful connection. Optional Configuration: Access your router's admin panel to enter ISP credentials if required, and configure Wi-Fi settings for your devices.

Additional Tips

Place both the ONT and router in a dry, ventilated area near power outlets, ideally with surge protection. For larger homes, consider mesh Wi-Fi systems to extend coverage.

Some IS

Ps provide a combined ONT/router unit, which simplifies the setup. By following this setup, your fiber optic internet will deliver high-speed, low-latency connectivity throughout your home.